They do not necessarily reflect the official policy or position of ABQ Mom, its executive team, other contributors to the site, its sponsors or partners, or any organizations the aforementioned might be affiliated with. Super Simple Paper Kite for Preschoolers Paper Bag Kite Craft Japanese Fish Kite Craft Simple Bird Kite Homemade Windsocks Newspaper Kite Plastic Bag Kite. You will need: 1 plastic or paper shopping bag 2 sticks that are each about 30cm long Cellotape Ruler Felt tip pen Scissors String or fishing line (the. Products that contain small parts may pose a choking hazard and should not be.0. With your pencil, make a dot about a finger-width from the top of the page. The opinions expressed in this post are those of the author. Disclaimer: As with all childrens products, adult supervision is required. Sharpen the crease down the middle of a double-page sheet of newspaper and then open it. Grab your kiddos and a few simple supplies, and you’ll have your own paper kite in no time. Make the best of Albuquerque’s yucky springtime wind.

Get outside on a breezy day and take your kite for its maiden voyage!.

A tail that is 5 to 6 feet long flies very well however, for young children, you might want to trim it to 2 to 3 feet in length. You can use lightweight ribbon, paper streamers, etc.

Turn the kite over and attach streamers to the back end.

Tie a long string (yarn, twine, etc.) through the hole.

Turn the kite over and punch a hole in the middle flap, right at the front of the kite.

You can use a small wooden skewer with the pointed ends cut off, a straw, or even an un-bent pipe cleaner. First, tie off the line to something like a dogs leash stake Second, loop something smooth and hard over the line and walk down the line. Recovering the kite requires a special technique. Letting out line is easy and more or less controlled.

Place a stabilizer across the top of the kite and tape it down corner to corner. The classic hardwood spool is what my local kite store sells.

Place a long strip of tape down the middle of the kite, connecting the two front flaps.This will give you your basic kite shape. Exact dimensions are not important, try to leave one inch at the top and two inches at the bottom. Fold the top layers towards the right and left so that the crease marks are at an angle.Take a single sheet of lightweight paper (construction paper is great!) and fold it in half so that shorter ends are together.Instructions adapted from Origami Resource Center

Diy kite simple